How to Fix Noise X3 Bass : One Ear Pods issue.

The Only Issue, I faced since the purchase of the NOISE SHOTS X3 BASS, was the connectivity or Bluetooth pairing. 

The Reason for writing a blog is that till date, not a single blog or right information is available on the internet or on the company's website to solve this issue.

Most Common faced issues, searched till date about this Ear pods are 

1. Pairing Issue.

2. Resetting the Ear pods.

3. One Ear Pod (Mono) get Connected.

4. Only one pod is working.

Here is Proper Solution. 

STEP 1. Turn off the Bluetooth on any of your devices and secondly, delete all the pairing devices available in the Bluetooth pairing list. 

STEP 2. Remove both the ear pods from the case, and press the ear pods for 

5 - 6 seconds, to turn it off - the ear pods should not blink. 

Step 3. - Put them back in the Case, for at-least 15 - 20 Sec 

(have patience)

Step 4. - Remove the Ear PODS and Press the Ear pods 2 times

(be fast as you can - this is important, if your are not quick enough to press it twice - you might have to repeat all the steps.

Step 5. On your Bluetooth, you will be able to see on the searching list - 

SHOT X3. 

(if SHOT X3 mono is still been seen - it indicates that the pairing was not successful.- repeat all the steps again)

STEP 6. Once Paired and connected successfully, you would be able to hear it from both your ear pods. (it is PAIRED)

I was personally able to perform this steps, to connect it successfully, and this is only solution which will work.

Thank You...and enjoy your music...